Operating Manual

Start

1. Starts always with clean fresh drinking water of the waterworks.

2. Warm up the bath to the right temperature during 24 hours.

3. Check the bath (with the circulation pump off) thoroughly on pollution and sedimentation.

4. Add 50% (500 ml) AquaPerfect® to the bath water.

5. After 14 days add again 50% (500 ml) Aqua- Perfect® to the bath water.

Na de 1^e. maand

1. Refresh approx. 5% - 10% of the bathwater.

2. Add 50% (500 ml) AquaPerfect® to the bath water.

3. After 14 days add again 50% (500 ml) AquaPerfect® to the bath water.

Na de 2^e. Maand

1. Refresh approx. 5% - 10% of the bathwater.

2. Add 50% (500 ml) AquaPerfect® to the bath water.

3. After 14 days add again 50% (500 ml) AquaPerfect® to the bath water.

Na de 3^e. Maand

1. Drain the bath and clean the bath, possibly with Whirlpool cleaner.

2. Fill the bath with clean fresh drinking water of the waterworks.

3. Repeat the cycle with a new set of AquaPerfect®.

WARNING: KEEP OUT OF REACH OF CHILDREN, NOT SUITABLE FOR INTERNAL USE